1986 ford bronco 2nd owner

1986 Ford Bronco Eddie Bauer Additional Info:

1986 Ford Bronco Eddie Bauer 4x4 Full size Clean Clear title in my name 2nd owner
I'll link my video of it at the bottom of it running
17K on the engine installed in 2001 it's been in my family for 22 years I have put a lot of parts on it, but we barley drive it anymore. It's always been a extra vehicle is why the low miles.
No I don't have the paper work on it we ordered it from Ford a new long block in 2001 my dad worked at the local Ford plant, he passed away I couldn't find the receipts.
New parts in past two yearsFuel pump less than 100 miles agoNew radiator about 8,000 miles agonew brake pads, rotors and, front calipers less than 2000 milesNew transmission linesnew water pump 2000 miles, I did break a bolt off changing it there is a tiny leak but it's small maybe some sealer will seal it, it didn't smoke or lose much coolant so I didn't mess with it.
New 4x4 lock outs less than 7000 just re greased less than 500 miles agoNew cap and rotor3" Magnaflow exhaust Stainless steal

The Badthe body has rust and some holes the body is savable, but needs work. I would just find a rust free body and change the whole thing. I still drive it sometimes, but the plates expired so not in a month or two.
There are some holes in the bed a couple by the wheel wells about 6 inches or so. the right fender is pretty rusty.it's drivable the front floor boards aren't too bad small holesI have the new fuel pump wired up manually to the fuse box I think the inertia switch is bad or maybe a wire fuse? but it run's this way drove it over 300 miles like this. Sometimes it will run normal if I unhook my wire sometimes not. That's why I think its an inertia switch.
It also need the back window put in I have it, but needs a motor and put in.
Thanks for looking good luck here is the video you may have to copy and paste it
https://www.youtube.com/edit?o=U&video_id=1hB3o2DXc6w