Make: | Chevrolet |
Model: | C10/K10 |
Trim: | Short Wheel Base C-10 4x4 |
Year: | 1970 |
Mileage: | 125298 |
VIN: | KE140Z117893 |
Color: | Blue |
Engine: | 350 |
Cylinders: | 8 |
Fuel: | Gasoline |
Transmission: | Manual |
Drive type: | 4WD |
Vehicle Title: | Clean |
Item location: | Mays Landing, New Jersey, United States |
1970 C-10 Short Bed 4x4, 350, 3 Speed, California farm truck. Very solid, easy repairs. Runs & drives. Thousands in new and used parts!
Vehicle Details
1970 C-10/K10 4x4, 3 speed manual transmssion that was converted to the floor shift sometime during it's life. This truck was shipped from California where it spent all of it's life on a farm as a work truck. This truck does have some rust in the usual places but not anywhere as bad as a 53 year old East coast vehicle. She has some dents and older repairs, but really solid with good bones. This truck is an original short wheel base (uncut frame), no body swap. She has a 4" lift kit and 33" mud terrain tires on factory 8" Truck Rallys with new center caps and good used trim rings. The driver side door has cracks in the window felt area so I picked up a rust free used 1970 door for a replacement. There is a small amount of rust above the windshield on the driver side, also outer floor area near the driver side door jam, also the passenger side cab corner needs work. I bought repair panels for both. I also have a good - used driver side fender. Over $11,000 in new and used parts alone! New special ordered Custom upholstered Highlander seat was installed recently, also purchased a top loader 4 speed transmission & shifter to swap out the 3 speed. All new interior with new gauges (tach & vacuum), door panels, window felts, weatherstripping, and steering wheel. All new engine harness, tach harness, fuse box and dash harness. New inner fender, air cleaner, & tune up. 350 V-8 with headers and dual exhaust, 12 bolt rear with 373 gears.$800 spent on seat upholstery alone, new Deluxe door panels and arm rests, new outer grille Chevrolet logo grille. Also new body bushings, RH inner fender (installed), outer rockers (not needed), replacement RH cab corner, outer floor patches (LH only needs replacing), new heater controls, defroster ducts, heater cables, outside door handles (installed) Please see pics.