1973 Camaro RS/LT w/many new parts

1973 Chevrolet Camaro RS/Type LT Additional Info:

1973 Camaro RS/Type LT project car with many new & used parts
Originally was 350-4bbl engine auto trans, but both are long goneBody has a lot of rust, especially rear quarters and rockers. Will need repairs/replacements. Definitely a project car.
The car itself is pretty much complete with the exception of the engine and transmission.Driver side window was removed many years ago during an attempt to begin working on it, but never progressed further. Window, regulator, tracks, etc. all included. Window is being held in place with straps to keep the weather out.Driver side door was taken off and is temporarily wired in place now.
I misplaced the keys for it, so had to drill out the trunk lock to get it open and disconnect the steering box to be able to move it around.
The car is up on blocks. I haven't tried inflating the tires in several years, so don't know if they'll hold air.
Many, many new and used parts are also included in the sale, many of which are Factory NOS parts I bought back in the 80's when I was going to restore this car myself. Included are parts to convert it to 4-wheel disc brakes, as well as parts to convert it to a manual transmission. Also many duplicate parts.
Here's what's included, in addition to the car itself:

New Factory Parts (NOS)

RS Endura Front Bumper

Type “LT” Emblems (3)

“Camaro” Fender Emblems (2)

Front RS Center Bump Strip

Front Spoiler

Front RS Grilles (2)

Front Parking Light Lenses (2)

Headlight bezels (2)

Auto Transmission Shifter and Knob

Rear view mirror

Rear window blow motor & grill

Big block oil pan

Windage tray (not sure if SB or BB)

Rear package shelf speaker grills (2)

Sun visor mounts (2)

Flywheel – small block

Underhood Insulation w/clips

Rear valance panel (between trunk lid and rear window)

Side door window felts & chrome trims - some water damage

Door Gaskets (2)

Door Frame Gaskets (2)

Ignition Switch

Headlight Switch

Turn Signal Switch

Ignition lock w/keys

Oil Pressure Switch

Water Temperature Sender

Neutral Safety Switch

Back-up light switch (stick shift)

New Aftermarket

Heli-core spark plug wires

Radiator

Heater Core

A/C Evaporator

A/C Expansion Valve

HEI Distributor

Alternator

Headlights

U/L Control arm bushings (8 total)

U/L Ball joints (4 total)

Center link

Idler arm

I/O tie rod ends (4 total)

I/O front wheel bearings and seals (both sides)

Anti-sway bar links & bushings

Small Block Motor Mounts

Oil Pump w/pickup

Used Factory

Extra set of tail light lenses (4)

Shifter, floor pedals, and clutch linkage to convert to manual transmission

Calipers, rotors, and backing plates to convert to rear disc brakes

Motors, regulators, wiring and console switch to convert to power windows

Small block valve covers – no PCV or oil fill holes

Front & rear window chrome trim

Rear window blower motor wiring harness, with dash switch

Front RS grilles (extra set)

Used Aftermarket

Clutch and flywheel

Small block bellhousing

Not pictured but also included:

Used

Small Block HEI Distributors (2)

Small Block Hi Capacity Fuel Pumps (2)

Accel Coil

Accel #20100T Distributor with wires

Turbo 350 Transmission Oil Pan w/built in cooler

12 bolt rear end cover

More parts included; I just can't remember them all. Great opportunity as a restoration project.
Buyer agrees to all parts AS IS; no guarantees made.
$100 Deposit due through PayPal within 24 hours of auction close. Deposit non-refundable.
Pickup within 14 days of close of auction. Full payment due at pickup. Cash or certified check only.