1978 Chevrolet Corvette Stingray - Pro Street Drag *RARE* WL88 Heads Fully built

1978 Chevrolet Corvette Additional Info:

For sale is a 1978 Chevrolet Corvette Stingray show car that has a large amount of after market and high end parts installed. The car is very well put together. The engine is a 454ci bored 60 over to a 468ci. If you know about rare Chevrolet parts, this should spark interest. It has 1967 WL88 aluminum heads. There were only 21 sets of these made from Chevrolet, rarity is an understatement. I have been offered a lot of money for the heads only, but don't want to separate from the car. It has a steel crank and 15.5:1 pistons. The cam is a custom made, not store bought, Crane Cam 804. Currently is has no mufflers on the car and sounds insane. There is a fuel cell where the factory gas tank is. It is tuned to run on 116 leaded. The transmission is a 2 speed glide with a line lock. Also, has a trans brake hooked up. There is an aluminum spoiler and wheelie bars installed. The engine made 730hp all natural. It is setup for the outlaw prostreet bracket racing, but has never been down the track. The body has been professionally widened almost 4 inches of both sides in the rear. The cost of just the paint materials was 15k. It is tubbed in the rear and tucks the big slicks. There is not a part of the body that was untouched, it is an unbelievable paint job. People just stop and stare at the amount of flake that is in it. The rollcage is NHRA certified and is painted silver.
Features:

• 454 Stroker Kit .60 Over - 468ci
• WL88 Aluminum Heads *********
• 15.5:1 Compression Ratio
• 2 Speed Glide Transmission
• Transmission Brake
• Line Locked Brakes
• NHRA Cage
• Runs on 116 Octane
• Body Widened In Rear
• Fuel Cell
• T-Top Roof

Looking to sell the car but open to trades. Do not need another drag car. Does not hurt to ask. Car is in Tampa, Florida.