/ /

1960 Willys CJ3A ('53 body)! Teal Blue, Fully-restored, Runs Great!

Make: Willys
SubModel: CJ3A
Type: Convertible
Trim: CJ3A
Year: 1960
Mileage: 13,000
VIN: W61226113045N
Color: Blue Teal
Engine: Commando 225 Dauntless V6
Cylinders: 6
Fuel: Gasoline
Transmission: Automatic
Drive type: 4WD
Interior color: Black Leather, Blue Teal body
Drive side: Left-hand drive
Vehicle Title: Clear
Item location: Bronxville, New York, United States

1960 Willys CJ3A Additional Info:

This Willy's jeep is one of the nicest in the country. It performs very well both on and off the road. The tub and the custom interior are in great condition, as are the canvas doors and soft-top (which has two sunroofs! and is included in the sale).

Now for the best part: this jeep is a 1953 in body only. The body is mounted on a modified 1986 CJ7 frame so it has a more modern drivetrain. Registered as a 1960, given the best-of-breed parts used in the build. Rear endsare Dana 44 in the rear / Dana 30 in the front; the rear with 355 gears. Transfer case is a Dana 20.

This jeep has power-steering! and cruises at 60 mph with one finger on the steering wheel. It also has an automatic transmission, so it is much easier to drive and turn that massive rubber. Transmission is a TH350 automatic, and the transfer case is out of a 1969 JeepCommando -- totally rebuilt. 1970 Buick 225 Dauntless 6-cylinder engine is also totally rebuilt. Entire jeep has new wiring from headlights to tail-lights, and a custom exhaust system. Rare Kelsey Hayesmagson new 31 x 10.50 Goodyear Duratracs. This jeep is not your average Willy's;It stops, steers and handles like a new Jeep and is a pleasure to drive.

Other custom features include a Warn winch, off-road lights, a large, hidden steel-box compartment in the rear floor, a CB/AM/FM radio, interior heater, complete roll-cage, and much more!

Here's a more exhaustive list of things done:

-install AM/FM antenna under dash

-install new fuel float in Custom larger fuel tank

-install front aux lamps on fenders

-relocate floor high beam switch 6" higher on floor

-install customer supplied AM/FM/RADIO/CB unit

-install/fabricate mounting of speakers under dash

-relocate cig plug to new spot in dash

-create a 12v accessory ignition source

-put fuel pump on a 12v ignition source

-upgrade High Output alternator 160/180 amps

-fabricate new sunroofs (2x) in soft top

-install 12 volt wiper motors

-install rubber stops on hood for windshield

-fabricate new exhaust

-powder coat all chrome pieces/trim in matte black

-fabricate/install 1" plates to raise rear up

-move front bumper to rear (fabricate mounting)

-fabricate new front bumper

-install tow bars into front bumper

-fabricate locking pin for passenger seat

-fabricate locking pin for rear tailgate

-fabricate 2" Chromoly nerf bars w/ flat step. mounting plates drilled to frame

-install sand grip tape to nerf bars

-rebuild BPO pattern Transmission with 4x4 output shaft, torque converter, and dipstick

-350 4wd multi case with short Chevy 4x4 output shaft

-custom modified stock drive shaft and 4x4 shaft

-D20 Shifter

-Trans cooler

-spec out and install larger/battery

-finish roll bar with padding

-fabricate removable top bars for doors (1 1/2 - 1/34)

-fabricate extra steel plate to protect gas tank from side impact

-fabricate under-hood reinforcements

-fabricate winch mounting plate and storage box (place winch controller/plug in box)

-move/mount winch wiring box to inside DS fender under hood

-move license plate lower to clear winch cable

-replace winch cable with super-strength synthetic rope (gray)

-fabricate larger gas tank

-install customer supplied am/fm antenna to DS rear panel - like CB antenna

-install front fender extenders, smooth out finish and paint matte black

-fabricate/install stainless steel brake lines

-install customer supplied old round mirrors,install a rubber stopper at base

-steering wheel adaptor for an S10 blazer

-remove exhaust manifold and ceramic coat black

-fabricate dual exhaust and quieter mufflers

-Powder coat side steps in matte black

-Front end winch, various related

-Security/hidden Storage bin & door

-Seat brackets

-half doors

-soft top door frame

-Ceramic Coat exhaust manifold


I reserve the right to end this auction early.