/ /

1966 Volkswagen 1300 US Spec

1966 Beige Volkswagen 1300 photo 1
1966 Beige Volkswagen 1300 photo 2
1966 Beige Volkswagen 1300 photo 3
1966 Beige Volkswagen 1300 photo 4
1966 Beige Volkswagen 1300 photo 5
1966 Beige Volkswagen 1300 photo 6
1966 Beige Volkswagen 1300 photo 7
1966 Beige Volkswagen 1300 photo 8
1966 Beige Volkswagen 1300 photo 9
1966 Beige Volkswagen 1300 photo 10
1966 Beige Volkswagen 1300 photo 11
1966 Beige Volkswagen 1300 photo 12
1966 Beige Volkswagen 1300 photo 13
Make: Volkswagen
Model: 1300
Type: Sedan
Trim: US Spec
Doors: 2
Year: 1966
Mileage: 130000
VIN: 116913463
Color: Beige
Engine: 1500 CC
Cylinders: 4
Fuel: Gasoline
Transmission: Manual
Drive type: 2WD
Interior color: Black
Vehicle Title: Clean
Item location: Mechanicsburg, Pennsylvania, United States

Additional Info:

The 1966 Volkswagen 1300 US Spec is a classic car with a beige exterior and black interior, featuring a 1.5L engine with approximately 130,000 miles on the odometer - true reading is unknown. The vehicle has a 4 speed manual transmission vehicle has 2 front seats and a bench seat in the back, 2 doors, runs on gas - better if you add a lead additive to each tank - also avoid ehtanol. This is a true enthusiast car.
You will notice the first 7 pictures were taken when I purchased this car in late 2016, all of the rest were taken this week. I got sick shortly after I purchased the car and was not able to do any restoration for about a year. Although I did some minor work to the car along the way, in 2018 I had the engine rebuilt, I only ran the engine once after it came back from the shop. In 2020, I began tearing it down, I removed the interior, and had some welding done to replace part of the pan - which can be seen in the pictures. What can also be seen is the rust in the usual spots, under the running boards. I discovered at that time that the rocker panels had previously been replaced. I also found that the left rear window seal had been leaking for some time and had caused quite a bit of rust at the bottom, some of which has been repaired, but it still needs some work.
This project requires previous experience to restore the frame properly, but it's not a lot of work. the body is in really good shape as is most of the pan. The primary trouble spots are the rocker panels and along the rear firewall. Although I have had the car for 10 years I've only driven it three times.
I have some new parts for it, including new rubber seals, window trim, various other parts - I can provide a list. As mentioned the engine is newly rebuilt, the clutch, and bearing have been replaced. I put new tar boards in the engine compartment, new engine compartment seal.
If you have questions please ask. The car is registered in PA, it spent a few years in North Carolina, it has always been garaged and I will include a car cover (pictured) with it.