Rebuilt 5.0 High-Output 5-Speed Lowered 1" Welded Roll Bar

1965 Shelby Cobra Factory Five MK3 Replica Stock#9702052 Additional Info:

1965 Shelby Cobra Factory Five MK3 Replica For Sale in Santa Fe, NM 87508 This MK3 was built in 2005 and is powered by a Ford Mustang 5.0 high-output engine rebuilt by Gasper Engines, paired with a Tremec 5-speed manual transmission. It has 14,000 miles since the rebuild and is shown with a red exterior with white racing stripes and a black interior. This vehicle has been meticulously maintained. Features Lowered 1" Welded Roll Bar Locking Gas Cap Chrome Accents Throughout Bumperettes Included (Not Installed) Owner’s Notes &#

1965 Shelby Cobra Factory Five MK3 Replica For Sale in Santa Fe, NM 87508

This MK3 was built in 2005 and is powered by a Ford Mustang 5.0 high-output engine rebuilt by Gasper Engines, paired with a Tremec 5-speed manual transmission. It has 14,000 miles since the rebuild and is shown with a red exterior with white racing stripes and a black interior. This vehicle has been meticulously maintained.

Features

Lowered 1"

Welded Roll Bar

Locking Gas Cap

Chrome Accents Throughout

Bumperettes Included (Not Installed)

Owner’s Notes

“Up for sale is my 1965 Factory Five Mk3 Shelby Cobra replica, titled as a 1965 and showing just over 14,000 miles. This is a well-sorted, properly built car that delivers the timeless Cobra look with reliable modern Ford power. Under the hood is a Ford Mustang 5.0 HO engine rebuilt by Gasser Engines. It runs strong, starts easily, and has the deep, aggressive sound these cars are known for. The engine is paired with a Tremec 5-speed manual transmission that shifts smoothly and makes the car an absolute blast to drive. It also features 3.55 rear gears, giving it excellent acceleration while remaining very streetable. Finished in bright red with white racing stripes, this Cobra has the iconic stance and presence that turns heads everywhere it goes. The paint presents very well, and the car shows clean overall. It has approximately 14,000 miles, has been consistently maintained, and was carefully driven and enjoyed. It is not a project or a partially completed build — it is a sorted, dependable car that you can get in and drive immediately. It pulls hard, tracks straight, runs cool, and delivers the raw, analog driving experience that makes these cars so special.

Interior heater, new steering wheel: 9/10/19, new AutoMeter Cobra gauges: 9/3/19, new fuel sending unit: 9/3/19, new clock and oil temp gauge: 4/9/24, installed new door panels: 3/19/18, chrome fire extinguisher, battery cutoff switch, floor mats with Cobra logos: 7/20/18, Lokar Black 5 speed shifter knob: 5/15/17, new brake and clutch 5.0 pedal pads: 9/29/25. New head gaskets, heads were machined and polished, replaced 1 piston: 10/17/18. Lowered front end 1" and aligned front end: 5/14/17, new front tires, 450 miles on tires: 5/21/17, new ceramic front brake pads: 9/29/25, Cobra logos on wheel spinners, chassis and frame black powder coated, wind wings and sun visors.

For anyone looking for a sharp, well-built Cobra with proven components and low miles, this is a great opportunity to own one that’s ready to enjoy. All receipts and papers for service, parts, and accessories go with the car in a 3-ring binder. Clean title in hand.”

For Assistance with Financing, Transportation, Or Inspections Call or Email Customer Support

402-502-8385