1966 Shelby Cobra replica, 427 body, 429 cid

1966 Shelby Cobra Additional Info:

youtube videos:

THESE ARE VIDEOS OF THE EXTERIOR AND THE ENGINE BAY.................

https://www.youtube.com/watch?v=1zVCESo5oP0

https://www.youtube.com/shorts/WjIkm_wYQmc

https://www.youtube.com/shorts/1y68BSwiOkk

https://www.youtube.com/shorts/XH_szHdnsYs

https://www.youtube.com/shorts/LE3tbPw9cfw

https://www.youtube.com/shorts/KkCNI21-Gjk

I had the engine rebuilt and a new rearend installed by Bryce Kumis Racing, Melbourne, FL. This was a six month project and completed in Spetember 2023. There is about 300 miles on the new build.

I have all the receipts. Here is a summary of the parts and work that went into the rebuild.....

New Edelbrock fuel pump

New fuel pump adapter

New Powermaster Starter

New piston and ring package

R & R pistons

Complete valve job

New seals

New Rear end rebuild

New 8.8 ring and pinion kit

R & R fuel tank and

New fuel sender

New fuel gauge

New complete rebuild of 429 cid engine

New roller cam

New spring kit

New MSD plug wiring

New headlights, taillights, frontlights

New rear adjustable shocks

New front shocks

New side wind deflectors

New sun visors

New high capacity radiator

New high flow radiator fan with shroud

New high volume oil pump

New hardened oil shaft

New phenolic carb spacer

New push rods

New power steering pump

New bracket and pulley kit for lowmount alternator

New Powermaster Race alternator

New belts

New MSD Coil

Sand blast and power coat intakemanifold

Sand blast and power coat timing cover

bore and hone block .030

hot tank

cleaned oil galleys

R & R oil plugs

R & R cam bearings

Main and rod bearing clearances checked

resized rods

machined the crank and heads

Sand blast and power coat thermostathousing

tank heads

surface heads

Speedometer adjustment

____________________________________________

THINGS I would do if I kept it:

upgrade the door hardware

install larger brake pads on the front

re-hang the passenger door