1955 Porsche Spyder Replica Car Perry-D

1968 Porsche 550 spyder Additional Info:

I hate to sell the car, but I have two little kids and I just don't have the time to drive it.
This model utilizes a Volkswagen Chassis with rear mounted engine and a Perry-D custom fiberglass body that is bolted directly to the chassis.
The car was built by certified welder and he built this car with a protective roll bar package that includes reinforcement under the dash and a roll bar behind the driver and passenger . The added stiffness of this setup helps this car to handle well.
-It is titled, registered in California.-It's registered as a 68 VW and therefore does not require a Smog certificate.-only the milage gauge works and the speed, the other two can be replaced for a few hundred dollars (see picture driving)-The car runs great anddoesn'thave any drivability problems.-The transmission is a '68 VW transaxle which shifts like any typical good condition VW transmission does. It runs at 70-75 mph with no problems. Higher gears can be installed if desired.-The engine is rebuilt and only has 2383 miles on it-The engine is a typical VW with single carb and not a high performance version.-roll bars under the dash and in the rear compartment behind the seat,plus the over the head roll bar U-Tube protectors which can be seen in the photos.-included is a built-in trickle battery charger that will keep the battery properly charged duringtimesthe caris not used.-installed an adjustable front I Beam as part of the front suspension. This allows the front of the car to be adjusted to the proper height level and also helps adjust the wheelalignment.
If you have any questions feel free to ask

On Jun-30-16 at 21:20:01 PDT, seller added the following information:

Update this has double carbs, I will be adding more picturestomorrow.
I hate to sell the car, but I have two little kids and I just don't have the time to drive it.
This model utilizes a Volkswagen Chassis with rear mounted engine and a Perry-D custom fiberglass body that is bolted directly to the chassis.
The car was built by certified welder and he built this car with a protective roll bar package that includes reinforcement under the dash and a roll bar behind the driver and passenger . The added stiffness of this setup helps this car to handle well.
-It is titled, registered in California.-It's registered as a 68 VW and therefore does not require a Smog certificate.-only the milage gauge works and the speed, the other two can be replaced for a few hundred dollars (see picture driving)-The car runs great anddoesn'thave any drivability problems.-The transmission is a '68 VW transaxle which shifts like any typical good condition VW transmission does. It runs at 70-75 mph with no problems. Higher gears can be installed if desired.-The engine is rebuilt and only has 2383 miles on it-The engine is a typical VW with double carb and not a high performance version.-roll bars under the dash and in the rear compartment behind the seat,plus the over the head roll bar U-Tube protectors which can be seen in the photos.-included is a built-in trickle battery charger that will keep the battery properly charged duringtimesthe caris not used.-installed an adjustable front I Beam as part of the front suspension. This allows the front of the car to be adjusted to the proper height level and also helps adjust the wheelalignment.
If you have any questions feel free to ask