1971 Hemi Cuda Clone Resto-Mod

1971 Plymouth Barracuda Coupe Additional Info:

1971 Hemi Cuda Clone Resto-Mod
No expense was spared in creating one of the finest Hemi Cuda Resto-mods out there. Built by Race Ready Technologies of Philadelphia, PA over an 18-month period, this is my dream car. I had planned on keeping it forever.
It started life as a 1970 440 six pack car. The body was stripped to bare metal and epoxy sealed. Custom fabricated torque boxes and frame connectors were installed to fortify the frame. Sound-deadening material was added to the floor, roof, inside the doors and inside the firewalls.
Then the real fun began. Mopar fans know Ray Barton and the incredible race engines he builds ... and the one he built for this care is no exception. A 472 cu. in. EFI Hemi putting out 650 HP and 585 ft. lb s. of torque!!
Below is a list of some of the other goodies put into this car:
Ray Barton 4 72 ci EFI Hemi650 hp and 585 ft. lbs. torqueFAST electronic Fuel InjectionTrue Flow Air Filtration TTI Ceramic H ExhaustRace Ready Technologies Frame Connectors and Torque BoxesRMS MotorSports Front Suspension and Power Rack SteeringA TI 727 Automatic TransmissionB&M "Hammer" Shifter Strange Dana 60 rear axle -3:7 rear gearsWilwood Brakes and Dual Master Cylinder with Bias ControlWheel Vintiques/Stockton 8' x 15' Front WheelsWheel Vintiques/Stockton 10' x 15' Rear WheelsBF Goodrich TIAYear One InteriorVintage Air A/CSony CD/FM with 4 Speaker SystemRace Ready Technologies Comer Weighted and Tuned Suspension
Unfortunately, since I took delivery of this car 12 years ago, 1 have only put about 200 miles on it. Life got in the way. My lack of time can be your good fortune. I have over $120,000 in receipts alone for this car but it is time to find it a home with someone who will drive it. Very reasonable reserve.