1951 Mercury CHOPPED BAGGED BRAND NEW EVERYTHING Accu air COLD AC 383 stroker

1951 Mercury Other Additional Info:

1951 Mercury Chopped and Bagged correctly
BRAND NEW EVERYTHING, just finished 1 week ago.
$54,000.00 in receipts after the purchase of the car and paint job. Over $100k in this build
A lot of time and money went into this build. Almost 3 years.
I purchased the car from a gentlemen's estate and it was already chopped but the motor, trans, chassis, 4 link, interior, bag issues, and much more.
I had the car torn apart and a Brand New 383 stroker installed with bass boat flake. The motor currently has around 100 miles.
Black CA plates, not installed yet.
Accu Air Air ride70 amp power wiring harness kitSingle 10 gallon tankAdel Clamps3/8" DOT air hose3" Cup KitE level touch pad mountedUniversal Air house II 3/8 port rear bagsAll airlines are grommeted and installed correctly
ExhaustMagnaflow muffler 3 chamberfull pipe and hangers
Rear EndRear endrebuilt and Chevelle 10 bolt Posi addedNew Drive shaft
A/CInstalled a full Brand New Vintage Air system with new linesHeater Control Valve wiring kitEvaporator mounting bracket kitRefrigeration line kitHVAC Bulkhead plateBinary pressure switchAC controls all wired into OG dash controls
ElectricalEntire new electrical system throughoutAA Wire harness 22 circuitWire harness kit with loom, terminals, and shrink wrappedAutometer temp senderAutometer oil senderRewire Brand New line to turn signals, headlights, horn, sockets, door poppersSecure headlights in frenchingL & R Spotlights are not wired up, only for showKeyless entryCurrently no stereo
UpholsteryEverything was torn out and redone.The vinyl is 50% recycled leather and 50% recycled vinyl.Pistachio colorThe hand feel is soft and feels correct for the car.You can get an interior from $3k to $25k, this interior worth speaks for itself.Carpet handsewn from the inside under to form the carDoor panels are brand new and aligned with tech 220 threadSeats were out of a 90's Buick and refoamed and shavedBrand new custom made door sillsThe photos do it justiceGauges work perfectly, digital and new.Steering wheel is Billet and matches
BrakesRebuilt master cylinderNew Brakes HosesNew wheel cylinders, pinion sealsNew brake drums and shoesSpeedometer calibrationAll lines replaced
Steering ColumnBrand New Ididit Tilt Column w shift chrome 30"Rebuilt the entire steering box, steering is very tight

Motor383 Stroker Brand New with 10o mies on it from testing700r4 transRuns so cleanEdelbrock 650 CFM Thunder AVSEdelbrock Fuel line kitNew oxygen sensor, throttle linkage, fuel pump, and fuel regulatorSpeedometer, brakes, and motor all calibrated
Wheels and Tires15x6/4.5-4.75 3.62" bs 61 AWC black wheelsP205/75/r15 2/5" Classic White Wall radials but look like bias ply
Photos show bagged and all the way up as well.
Every single thing on this car works correctly.
Its not 1000000% show quality yet.
Trunk is probably going to be done in the next 2-4 weeks if not sold.
Paint is 2 years old and isn't perfect. Matte brown metallic. Small tiny chips in paint on certain areas which are being touched up.
Will consider trades and cash.
Don't low ball or waste time.
Test drive with proof of funds, no problem.
email @drkcustomz@yahoo.com