Make: | Land Rover |
Model: | Defender |
SubModel: | V8 110 |
Trim: | Orginal |
Year: | 1985 |
Mileage: | 156,345 |
VIN: | 00000000000000000 |
Color: | grey |
Engine: | 3.9 V8 |
Fuel: | Diesel |
Transmission: | Manual |
Drive type: | 4WD |
Interior color: | Brown |
Drive side: | Right-hand drive |
Vehicle Title: | Clear |
Item location: | Rye, United Kingdom |
Very original county station wagon. Ideal for classic car collector.
Like many classic Land Rovers the chassis was starting to show its age so we have carried out a frame off restoration on this Defender and then left the original body work and interior intact.
Even thoughit would have been far easier and cheaper to replace the chassis with a galvanised chassis we decided not to as it is a matching chassis/Vin number/ original enginevehicle.
It has had uprated LRI and Bilstein suspension set up along with a rear suspension anti roll/ sway bar to make create a far superior driving experience along with a full stainless steel exhaust system. These changes are reversible should a purist prefer to change it back to factory original.
Work carried out:
-Remove body from chassis for chassis work / refitting of body after chassis work
-Shot blast chassis, radius arms, axles and chassis mounting brackets
- Repair chassis corrosion, including replacement:- Rear spring mounts, bulkhead out riggers, bump stop mountings, Rear Anti roll bar mounts, station wagon body crossmember and repair sections of main chassis rails and body brackets
-Etch prime and paint chassis in satin black 2k top coat
-Etch prime and paint Axles, radius arms and suspension brackets
-Remove suspension bushes and refit with supplied super-pro bushes
-Strip clean / paint swivel housing and clean and paint rear brakes
-Adjust Swivel bearings. Replace front brake discs, pads & callipers. Replace rear brake shoes & brake cylinders.
-Replaced all suspension and all body mounting bolts and some chassis
-Replace engine camshaft using 3.9 camshaft, new followers, timing chain & sprockets.
-Repair to front to rear wiring harness
-Replace Faulty Head Light Switch
-Replace exhaust system with Double S stainless system including tubular manifolds
-Replaced 1x track rod end 1x drag link end and drop arm boot.
-Replace faulty alternator
-Replace Battery
*We have been informed that the previous keeper recently had the gear box rebuilt but we do not have paper work to support this.
Parts Fitted *More parts may have been fitted than shown on list below as so much work as been carried out.
ALTERNATOR - V8 45 AMP
VOLTMETER - DEFENDER
BRAKE CALIPER - 110 FRONT RH >HA
BRAKE CALIPER - 110 FRONT LH >HA
BRAKE PADS - 110 >HA
BRAKE DISC - 110 NON VENTED
BRAKE CYLINDER - 110 REAR RH
RTC3168 LH OEM
BRAKE SHOES - 110 REAR OEM
BATTERY - VARTA E24
EXHAUST SYSTEM - 110 V8 STAINLESS PERFORMANCE
SPARK PLUG - V8
ROCKER COVER GASKET - V8
THERMOSTAT - V8
VALLEY GASKET & SEALS
WATER PUMP GASKET
FRONT COVER GASKET
SEAL - V8 CRANKSHAFT FRONT OEM
OIL FILTER - V8/TDI OEM
CRANKSHAFT SPROCKET
CAMSHAFT SPROCKET - V8
TIMING CHAIN - V8
CAMSHAFT - 3.9 EFI
SWITCH - BRAKE PRESSURE VALVE
HOSE - WATER PUMP TO HEATER OUTLET
HOSE - WATER PUMP TO HEATER INLET
PAS BELT - V8
LIGHT SWITCH
TRACK ROD END - RHT
FUEL PUMP RUBBER MOUNT
BUMP STOP - REAR
BRAKE PIPES & FITTINGS
BRAKE FLEXI HOSE SET FRONT & REAR
FULCRUM BRACKET INC A FRAME BALL JOINT OEM
ANTI ROLL BAR LINK
TURRET MOUNTING RINGS - PAIR
SHOCK ABSORBER TURRET
BODY CROSSMEMBER - STATION WAGON - GALVANISED
ANTI ROLL BAR CAHSSIS BRACKET
BUMP STOP CHASSIS MOUNT
SPRING MOUNT - 110
BULKHEAD OUTRIGGER RH
BULKHEAD OUTRIGGER LH
FRONT + REAR 110 UPGRADED 1” LOWERING SPRINGS
H. DUTY REAR ANTI SWAY BAR
SUPERPRO SWAY BAR CLAMPS + BUSHES
SUPERPRO BUSH KIT
On site AA or RAC inspections are welcome