Make: | Jeep |
Model: | CJ |
Year: | 1984 |
Mileage: | 80,000 |
VIN: | 1JCCM87A3ET004725 |
Color: | Garnet |
Engine: | 258 Cubic Inches |
Cylinders: | 6 |
Fuel: | Gasoline |
Transmission: | Manual |
Drive type: | 4WD |
Interior color: | Garnet |
Vehicle Title: | Clear |
Item location: | Rochester, New York, United States |
Finding a restored Jeep is relatively easy, finding an original survivor is not so easy.
Up for sale, my 1984 Jeep Survivor CJ-7. This has not been restored and is mostly original.
The front grill and windshield frame have been repainted. The original carburetor has been removed as well as the AMC spark box (parts saved and they go with the Jeep). An Old Man Emu lift kit has been installed (original springs were shot, but the mounts have been saved).
I use this Jeep as my daily driver in the summer, it is garaged and driven without the doors and top.
It is an original soft top Jeep, but the original top was gone when I purchased it and it had been replaced with a hard top and doors (I have painted the doors to match the Jeep). I have since found and purchased an original Wilco Garnet soft top and doors. They have never been fitted to the jeep (which is an extensive process, I do have the instructions). The rear window of that top has a one inch cut in it. Garnet is a rare color and these tops are very hard to find. It goes with the Jeep.
Year & Model...........1984 CJ7
Engine......................258
Transmission............T176 (This is the heavy duty 4 speed transmission)
Transfer Case...........Dana 300
Front Axle.................Dana 30
Rear Axle..................AMC 20 one piece axle
Interior.....................Original Seats, Carpeting (I have one extra front seat cover)
Exterior.....................Side steps and at least 80 % of the original paint has survived.
.................................Front Original Tow Hooks with Keepers
.................................Hard top, one set full hard doors, Original space saver spare.
Wheels……………..There are five Laredo 8 inch wheels
Misc..........................Power Steering, Tilt Steering Wheel, Side Steps, Engine Compartment hood light,
……………………….under dash courtesy lights, Original Jeep roll bar padding, Original Jeep Steering Stabilizer
..................................Fuel Tank Replaced, Fuel Tank Skid plate redone, Frame reinforced for trailer hitch
..................................This vehicle has never towed anything
……………………….(This reinforcement was done using existing bolt holes and no modifications have
………………………been made to the Jeep itself), The tach and clock are aftermarket and the
……………………….speedometer was replaced (I do still have the original)
..................................Original rear Jeep Bumperets
Stuff you just could not leave alone
Tires.......................31X10.5X15
Suspension..............2.5 Old Man EMU lift
Steering..................HD Steering Shaft, AGR Power Steering (stock style) gear box, Tie Rod Flip
Ignition..................."Nutter" with MSD Box (AMC computer and ignition box removed, but saved), MSD
…………………….. Blaster Coil
Cooling...................Spectra Premium Heavy Duty Radiator, Fan shroud added, Flex Fan
Heater....................Blower Motor Upgrade
Valve Cover.............AMC Plastic cover removed and replaced with Cast Cover
Carburetor...............Weber
Headlights...............Direct battery voltage with relays, Correct era KC Driving lights added
Grounds..................Components under hood have been ground bonded
Dash......................Clock and Tach added
Radio......................Am / FM radio swapped for AMC AM / FM / CB radio
Problems
1) If left sitting more than 3 days, the carburetor bowl drains back and the engine must be cranked three times to get fuel back to the carburetor.
2) The steering does not return to center after cornering, the front end has been aligned and 8 degree caster wedges have been added. A newly professional rebuilt original steering gear box comes with the Jeep.
3) Rear brakes have started to squeal on the first application after sitting (needs a brake job)
4) After these pictures were taken the left front bumper was hit and bent back. The only damage is to the bumper itself. I am in the process of replacing it.
5) For off road use only (emissions have been removed (and saved)).
6) There is a burn hole in the front carpet from a spot light that was left on laying on the carpet
Most all of the projects on this Jeep have been documented on my web site. Google “Lever Family Racing” and look under “My Vehicles” tab