/ /

1994 Ford Bronco XLT - 4wd, Keyless entry, Handling and Towing Packages

1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
1994  Ford Bronco
Make: Ford
Model: Bronco
Trim: XLT
Year: 1994
Mileage: 205,000
VIN: 1fmeu15h2rlb09324
Engine: 5.8L, 351ci
Cylinders: 8
Fuel: Gasoline
Transmission: Automatic
Drive type: 4WD
Interior color: Opal
Drive side: Left-hand drive
Vehicle Title: Clear
Item location: Corpus Christi, Texas, United States

1994 Ford Bronco XLT Additional Info:

The truck is a relatively fully loaded XLT, it has the two-tone paint scheme thats original and faded on the roof and tailgate, it also has the typical dents for an older vehicle but most could be gotten out with a PDR guy probably. (should be cheap to redo only those panels if one wanted to). It has a 3.55 Limited Slip Differential, quad shock front end, overload leaf springs in the rear, larger front sway bar and a rear sway bar (part of a factory handling package), electric trailer brakes and controller, a factory KEYLESS ENTRY SYSTEM, power locks, mirrors, windows, manual seats w/ power lumbar, Removable hardtop, factory AM/FM/Cassette Stereo, 4 Wheel ABS, 4wd w/ electric shift transfer case and auto locking hubs, A/C and Heat (both work excellant!)
Now for all the parts that have been serviced, replaced, or rebuilt...
Interior:
-Carpet (passenger and cargo area with mass backing)
-Headliner (front and rear)
-Seats have been replaced for another original set in much better shape
-Radio was switched for an original unit
-Rear armrests have been replaced (the originals had broken hinges)
-Replaced the rear cargo light and front overhead light
-Replaced the driver's armrest support bracket
-New front and rear speakers
-Redid all the seems and joints w/ new sealer (no more leaks going through the rain-soaked roads)
Exterior:
-Replaced the hood (dented)
-Replaced the passenger fender (dented)
-Placed the faded headlights with oem ones
-Replaced the original taillights
-Replaced the warped cowl panel
-Replaced the broken antenna
-Replaced all the seals on the truck (doors, window sweeps, and track felts [side and rear], hardtop seal, tailgate seal, cowl seal)
-New fog lights
-Replaced rear bumper
Suspension:
-1" lift
-All new shocks (Quantity 6)
-New upper and lower ball joints
-New inner and outer tie rods
-New I-beam bushings
-New radius arm bushings and brackets
-Recent alignment
-NEEDS a new drag link
Drivetrain:
-Rebuilt TRANSFER CASE (2 months ago)
-Rebuilt Transmission VALVE BODY and fluid change (9 months ago)
-Rebuilt and balanced Driveshaft (7 months ago)
-All new Wheel Bearings and axle bearings (4 months ago)
-New TIRES on all 4 corners with warranty and road hazard (6 months ago)
-New Brakes (front rotors cut and new pads, rears were cleaned and adjusted and one drum replaced) (4-5 months ago)
-New Starter (5 months ago)
-Replaced the AUTO LOCKING HUBS (5 months ago)
-Replaced the electric shift transfer case motor (3 months ago)
-Replaced ECU (original one had a burned resistor and diode which caused idling problems and the trans to shift very late)
-New Alternator (5 months ago)
-New Battery (4 months ago)
-New MAP sensor (2 months ago)
-New IAC valve (1 year ago)
-New TAB and DAB solenoids (for emissions)
-Repaired all vacuum lines (has excellent manifold pressure)
-Has one new rim (original one was bent)
-Replaced the rear axle for one that has a limited slip out of an f150
-Rebuilt rear window motor
-New fuel filter (6 months ago)
-New plugs, wires, cap and rotor (6 months ago)
-New harmonic balancer (12 months ago)
-New belt (a couple weeks ago)
-New idler pulley
-New belt tensioner
-Cleaned and resealed Throttle Body
The Bronco has a few leaks but nothing major, it leaks oil as a small drip and power steering leak is small from the gearbox.
This vehicle is being sold as is without warranty.