1986 Dodge D250 Flat Bed Welding Truck

1986 Dodge Ram 3500 D250 Additional Info:

This truck has new lower ball joints, drag link, inner & outer tie rod ends, brakes front & rear,rotors & calipers, axle seals front & rear, radiator, fuel pump, tires, wiper motor, Flomaster series 40 muffler etc. Miller Trailblazer 302,10,000 watt generatorwith only 170 hrs on it and weather proof cover,12VSsuitcase feeder, 200' of leads, Ingersoll Rand 135 psi air compressor, 4 aluminumdiamond plate tool boxes, everything was purchased new. Bed & racks were custom built with removable cross bars and uprights, primed with zinc chromate and painted with Rustoleum black and the underside isfully undercoated. Frame was extended a foot at the rear, welded & fish plated so body is 9' long and has a lockablestorage compartment built in below the bed. This truck has not been used since 2013 was kept in a garage until 3-2016 and has had about 1,000 miles put on it since parts were replaced. it has a little rot on the drivers side rocker panel and some surface rust on the roof from worn paint and a little on the floor boards on the insidealthough theyare still pretty solid. The clutch chatters a little bit when starting out but does not slip and when cold it will give a puff of smoke when started,the compression in all cylinders is good just needs valve seals from old age and sitting. This truck runs and shifts great remember it is a 1986 not a 2006.