1978 datsun 280z - TRACK MONSTER 2JZ Swap - Pro-Built 150k Invested

1978 Datsun Z-Series Custom Additional Info:

Watch Video

Video will open in a new windowUsing the eBay App? Paste link into a browser window:

1978 Datsun 280Z - with over 150k invested in this Professional-Built Track Monster!

• 2JZGTE Fully Built Toyota Supra MK IV 3.4 Liter Stroker Motor

• 807 HP and 675 Foot Pounds of Torque on Mustang Dyno @ 34 pounds psi

(Conservatively Tuned by Custom Concept Motorsports) Conversion to Dynojet

-928HP!

• PRP Nissan R35 Coil Pack and Bracket

• Wiring Specialties Pro Series Engine Harness

• Injector Dynamics 2200 cc Injectors running E85 Fuel

• AEM Infinity ECU and CD7L Carbon Dash Management with 7” Screen

• AEM Flex Fuel Sensor

• AEM Vehicle Dynamics Module

• AEM MAP, Oil, & Fuel Pressure sensors

• Autometer GPS Speedo and Tach

• ARP L19 Main & Head Studs

• Billet Main Caps

• CP Carrillo Pistons

• Brian Crower – 1500 HPP BC Connecting Rods

• Balanced & Blueprinted Block

• Port Polished Head

• Brian Crower 276 Cams, Valves, Springs and Retainers

• Garrett GTX42R turbo with Tial V-band exhaust housing

• Dual Tial 50mm Blow Off Valves

• Tial 50mm Wastegate mounted on custom intercooler

• All -AN lines for plumbing

• Q45 Throttle Body

• ATI Super Damper Crank Pulley

• Turbosmart Oil Feed line regulator

• Turbo blanket, Zy-coated manifold and downpipe (also heat wrapped)

• HKS Triple Disc Clutch

• Toyota Supra 6-Speed manual transmission (V160)

• Adjustable Electric Power Steering (EPAS) on Woodward column

• 12 Gallon ATL Fuel Cell with Radium drop in surge tank with 2 Walbro 450LPH E85 high

pressure pumps and 1 lift pump, ATL Fuel level sender

• R230 Nissan Rear End – with Drive Shaft Shop 1000 hp Axles & Drive Shaft & Stub shafts

• Cusco RS 1.5 Way Clutch type LSD (LSD 166 L15)

• Brakes – Wilwood 6 piston Super Lites (F) and 4 piston (R) with Chase Bays Hydraulic

Handbrake (All new hard lines)

• Chase Bays Manual Brake Master Cylinder with Proportioning Valve (Wilwood)

• Chase Bays Clutch Master Cylinder (Wilwood)

• Wilwood BP-30 brake pads

• Techno Toy Tuning Suspension with Koni Adjustable Sport Struts

• Techno Toy Tuning RCA’s, Power Brace, Inner and outer tie rods, GTX2 Control Arms, Tension

Control Rods, Rear Lower Control Arms, R230 Mustache Bar, Drop Mounts and Dogbane

• Techno Toy Tuning 5 lug conversion front & rear

• Techno Toy Tuning Camber Plates front & rear

• Interior – OMP HTE-R 400 FIA Race Seats with Schroth 6 point Hans Harnesses

• Momo Suede Dish Steering Wheel

• Cage – Heavily reinforced Cage Work front to back built by Top Garage Fabrication

• Custom Aluminum, Firewall, Door Panels, Floor Boards and Fuel Cell Cover by Big Oak

Garage

• Bryce Thomas custom radiator and shroud with -AN lines• Exhaust – 4” Downpipe and converts NASCAR oval tubing out the back for low clearance

• Skillard Aluminum Splitter with Type 2 Air dam

• Optima Red Top Battery

• Fire Extinguisher mounted to Cage

• LED Headlights with Yellow Lamin-X

• Satin 3M Dark Gunmetal wrap

• ARP Wheel Studs (12x1.5mm)

• 2 sets of wheels & tires included

• 17x11 – 17x10 ADV1 ADV5 3-pc wheels Death Bronze finish 315/35ZR17 – 255/40ZR17 Toyo

•18x11 – 18x10 Rocket Attack wheels RPM7 finish on 315/35ZR18 – 255/35ZR18 Yokohama