wqsqlkbhń1957 Corvette Project Car - PRICE REDUCED

1957 Chevrolet Corvette Additional Info:

PRICE REDUCED $ 33,000

This 1957 Corvette project car is from Arizona in gray primer with a no rust frame. The frame, under side andgas tank area of the car have been restored. A front clip was installed by the previous owners body shop. There has been a body repair on left rear quarter and above tail pipe which appears to be well done although the inner quarter panel bonding strip is missing. This car needs minor body work to fix the fiberglass chips caused from transport, paint, and assembly. I believe the car was originally thought to be a 1956, hence the 265 CI motor. Checking the frame serial number it is definitely a 1957 and titled as such. The VIN, Frame serial number and title all match.

This Corvette has a 265 cubic inch engine NOM (Not Original Motor) with a Warner T10 3-speed manual transmission already installed. The car does not run or drive at this point. Included with the car are the following parts most ofwhich are original 1957 used parts in good and fair condition.Please take the time

to price the parts listed yourself to realize what a value-added purchase this is.265 ci engine, T10 manual transmission, starter, eight piece chrome bumpers, two seat tracks, two seat adjusters, two seats (two seat springs, two seat back springs), two seat supports, four beige seat covers (seats/backs), two pieces deck lid seat back chrome, steering wheel (beige), four wheels (with nubs for hubcaps), steering column, four wide white wall radial tires, side view mirror, rear view mirror, signal seeking AM radio, three piece radio grill, radio bezel, fuel/temp gauge, battery/oil gauge, four new gauge lenses, tachometer, speedometer, speedometer new glass, parking brake light indicator, headlight switch, headlight parts (cups/liners/trim rings), door upper inside rail parts, two step plates, trunk liner cardboard, door parts (window reinforcements, rear tracks, one front track, two front runs, two exterior moldings, one interior molding, two access plates, two nut plates, one trapeze, two openers, two exterior door handles, two window regulators, door trim rail assembly), one front license plate bar, windshield and frame, two door sills, clutch inspection pan and cover plate, one new hood release cable, two door windows, two door posts with tabs, 2x4 intake manifold, 2x4 air cleaner, oil pan, two 7-fin corvette valve covers, radiator, upper and lower fan shroud, fan blade, fuel pump, generator, brake master cylinder, non-Corvette distributer, water pump, water pump pulley, front grill and surround, four fender scoop chrome inserts, two front and rear emblems, two fender emblems, five pieces ignition wiring shields, four spark plug shields, one fuse block, head/tail lights, voltage regulator, horn relay, horn button, two horns, dash rail, dash rail cover, dash reinforcement plate, new fire wall insulation se, two window cranks, two spacers, two window openers, striker plate (plate/shim/bezel), two gas tank straps, two exterior door handles and catches, red carpet set, two red door panels with chrome and new cardboard, two red kick panels, horizontal bumper reinforcement bar, two bumper brace seals, gas filler door, gas cap, one windshield washer fluid reservoir red top (reproduction), windshield washer bottle, windshield washer foot pump, beige soft top, soft top frame, license plate bracket, glove box door, two female hood pins, six pieces stainless cove trim, 1957 assembly manual, laminated wiring diagram, reproduction aluminum VIN plate.Parts have been inventoried and wrapped for transport.

Important numbers (as best as I could see/read them):

GM differential (3725899) K1160

Warner T10 transmission

Main case 3813490

Tail shaft 3108563

Delco shocks 739155 008913

Block casting number 3720991

Block S/N 0637206F56FB

Powerpack Heads 3725306

Generator 1102115 8A24

Brake master cylinder 34433

Water pump 3704911

Harrison Radiator 57A 3133689

This car has a clear Texas title. It is being offered to the Corvette enthusiastwho loves these early model carsor to a Corvette restorer. My intention in purchasing this car originally was to restore it to as close to original looking as possible and make it a driver. I am unable to complete the car so I am offering it for sale.

A non-refundable $500 deposit through PayPal is required from the buyer with in 24 hours of the close of the auction. If the deposit is not made within the 24 hour period, the car may be relisted. The deposit amount will be deducted from the final sales price of the vehicle. Full payment is due within seven days. Cash is always welcome or a certified bank check or certified bank money order. Payment in check/money order form must clear both banks before the car is released and the title signed over.

Please no trades.Sale is final and refunds are not offered. Sale is offered to domestic US residents only - NO foreign sales. e.

Questions? Text or call Mike at (817) 925-5756 between 1:00 - 8:00 pm CST.