1970 Chevy C/K 10 4x4 Long Bed Truck - Daily/Work Driver - Reliable
| Make: |
Chevrolet |
| Model: |
C-10 |
| Type: |
Standard Cab Pickup |
| Year: |
1970 |
| Mileage: |
115000 |
| VIN: |
CE140Z119931 |
| Color: |
Brown two tone |
| Engine: |
350V8 |
| Cylinders: |
8 |
| Fuel: |
Gasoline |
| Transmission: |
Manual |
| Drive type: |
4WD |
| Interior color: |
Brown |
| Drive side: |
Right-hand drive |
| Vehicle Title: |
Clean |
| Item location: |
Mill Valley, California, United States |
1970 Chevrolet C-10 Additional Info:
1970 C/K 10 4x4, 4" suspension lift, 8' long bed, 350 V8,- new Edelbrock 1406 4bbl w/electric choke- strong oil pressure and compression. no unusual noises from motor
- sm465 4 speed manual transmission (with granny gear) - shifts smoothly. The granny gear has been noisy since I got it, but I don't use it at all- NP 205 ratio 196 transfer case- Dana 44 front differential, GM 12 bolt rear diff - 3.73 ratio- 33" Cooper Discover tires (50% tread left)- 15" aluminum powder coated black aluminum bead bolt wheels- Wheels and tires alone could sell for close to $1000 in current condition- Manual front disc brakes (50% left), rear drums (50%). Was planning on adding a vacuum brake booster when I bought but stops well enough without.- Power Steering - starting to make a little bit a squealing noise turning very sharply at slow (5mph) speed But handles well at driving speeds - nice tight front end with no pull, shake, wobble - hands free wheel at 70 - 75 mph- Has fresh oil change/filter and tune up, air filter, plugs, points and the new carb idles smooth at both low and high idle.- Frame is straight and rust free. Cab has a few rust issues but relatively minor. Rocker panels were replaced and floor panels were patch welded. One of the cab mounts and surrounding metal has rust but not a structural issue. Bed has only very light surface rust, no areas of weakness- Exhaust pipe/muffler/manifold are older with surface rust but no rust through or leaks- Just got a new front drive shaft (you can see from the pictures I haven't installed it yet but will...the old one had a slight wobble and cracked mounting plate)- Has a Rack-It cab over contractor rack. These cost $1500 bucks new for an 8 foot bed.....and good luck finding a used one anywhere, they don't seem to exist- new sliding back window with new rubber- Trailer hitch and wired for trailer brakes
Keep in mind that all comments on condition are relative to a 50 year old heavy duty truck, not a more modern vehicle!
The truck makes a solid daily work driver (short distances better since gas mileage on these things is brutal) and a great base for something prettier. I have owned for 2+ years and never had a mechanical issue while putting about 12,000 miles on it. Total mileage unknown. Don't hesitate to email with any questions. I have many more pictures so just ask. Also have video. And a list of stuff I would fix if I had time/money. I am gonna put it for sale locally in a few days also so auction can end at any time.