1980 chevy custom corvette

1980 Chevrolet Corvette Additional Info:

1980 corvette custom built
Motor 350 CHEVY 4 BOLT MAINÃÂ
PLUS .060 BORE
CRANK REGRIND MINUS .010 ON MAIN BEARINGS PLUS .010 ON ROD BEARINGS
10 TO 1 COMPRESSION FLAT TOP FORGED PISTONS
MILD CRANE CAM
ALL NEW SPRINGS RETAINERS AND SEALS ON HEADS
1.7 RATIO ROLLER ROCKERS BLUE RACER
CAMEL HUMP OR FUELIE HEADS ÃÂ 2.02 INTAKE VALES 1.80 EXHAUST VALVES
EDLEBROK VICTOR JR INTAKE BUT I REPLACED IT WITH A PERFORMER MANIFOLD AND A HOLLEY VAC SECONDARY 750 CFM STREET ABILITY
EDLEBROK ALUMINUM VALVE COVERS
EDLBROK ALUMINUM TIMING COVER
ALUMINUM WIRE LOOMS AND TAYLOR WIRESÃÂ
THIS MOTOR WAS BUILD BY MARTIN MOTORSÃÂ
IT RAN 11.80 IN THE 1/4 MILE IN A 3300 LB CAR BEFORE I PUT IT IN THIS VETT
MOTOR ONLY HAS TEN PASSES ÃÂ
THE REST OF THE CAR WAS A CHASSI OFF WITH TONS OF MODS.
rack and pinion steering (steeroids system)
Drag vet 6 link rear
Rebuild rear diff with new clutches and 373 gears
Hurst shifter and linkage kit
Custom cross member for 3" true dual exhaust
Flow master mufflers and fill 3" exhaust with
Long tube headers
Aluminum radiator
Electric fans
Drag seats with 4pt harness
Marshall gauges
New tires all around with 150 miles
150 miles total on car since build
All new slotted rotors
New pads
New calipers
New master cylinder
All new break, and fuel lines
New tank
Just about everything is new and I have photos of the build and all receipts. This is a fast fun 4 speed street car that will be no slouch on the drag strip.