1936 CHEVY 1/2 PICKUP PROJECT

1936 Chevrolet Other Pickups Additional Info:

1936 Chevy 1/2 ton pickup. Started to get it running but another project took over.
Body: Pretty solid. All pieces are there. There is a small amount of rust on each side of the cowl section and where spare tire sits. Tailgate is home made but works fine. The two areas where the wood door supports were have been replaced with metal. The removable floor section was missing and I started to fab on up. I didn't finish it but have the steel, I believe the original floor was wood. Wood in the bed has been replaced. The front edge of the bed needs better support.The truck actually looks good the way it is,I wanted tokeep the(real) patina look, not thefake patina ones that do not look real.
Interior: Dash and gauges are all there, not hooked up. Its still set up for the 6 volt system. Steering works fine. Seat springs are there and in good condition. Windshield will crank in and out. Windshield is cracked, missing both door glass.
Mechanical: Engine is a 216 that runs, clutch and transmission work. I put the fork in the wrong position but easy fix. Transmission is a crashbox 4 spd with the reverse lever. Radiator held water but did not pressure test it. Enclosed driveline seems to be alright. I had the master cylinder rebuilt but did nothing else on the brakes.
All else: This is a project vehicle, it does not run. I Have 2 16" wire wheels that go with it. Extra engine, bell housing, and trans to go with it if you want them. You would have to tow this vehicle. I DO NOT HAVE A TITLE, only a bill of sale and the bill of sale from prior owner. The box above makes you enter something for the title, so I entered clear. If you buy it and are in California, I can help with the paperwork on getting a Title. I have done it several times with a Bill of Sale, Vin verification, Statement of facts, and weight cert. for trucks.