Make: | Chevrolet |
Model: | Chevelle |
Type: | Convertible |
Year: | 1967 |
Mileage: | 11111 |
VIN: | 135677b127240 |
Color: | Tuxedo black |
Engine: | 402 |
Vehicle Title: | Clear |
Item location: | Hercules, California, United States |
1967 Chevelle Convertible for sale.
5 of VIN: 135677B
Translates to 6Cyl Malibu 2 dr convertible Baltimore, MD Plant
Car was purchased out of Baltimore area in 2015.
VIN number DMV verified since it was an out of state vehicle.
Clean title.
Approx. 75% of frame off restoration completed.
Frame has been notched in rear wheel area to accommodate a larger wheel.
Frame was sandblasted and all holes were completely repaired to 100% round.
Powdercoated 40% gloss.
Stock control arms - sandblasted, powedercoated w/Moog ball joints/bushings.
Rest of suspension is replaced with Moog parts (tie rods, idler arms etc)
UMI 2" lowering springs Front & Rear
Bilstein RCD shocks Front & Rear
UMI Sway Bars Front & Rear
The Right Stuff Disc Brakes, 11" rotor, Calipers powder coated Black
4 wheel Power disc brakes
Stainless steel Brake & Fuel lines
Gas tank w/ fuel sending unit installed
ALL parts on frame are NEW
BBC 402, casting number shows out of a 1971/72
Engine ran in 2015 when vehicle was purchased.
In 2017 I replaced:
Oil pump
Timing Chain
Hydraulic Roller Camshaft - Howards 225/231 .567/.578â€
Roller Rockers/Valve springs/Push rods
Edelbrock Performer Intake manifold
Quadrajet built by SMI (Sean Murphy Inductions) in SoCal tp engine specs
Sanderson Headers
March Performance pulleys and accessory brackets (low alternator mount)- Powderercoated Black
Tuff Stuff 140amp alternator
P/S pump powdercoated black
Dewits aluminum radiator with (2) 12" fans.
Car has pedals for 4 speed trans installed
NO TRANS
10 Bolt rear end.
Has NEW summit axles but will need new ring/pinion/gears.
Unknown ratio
When vehicle was purchased in 2015 it had recently had the trunk and floor pans replaced by the previous owner.
Body was sanded down to bare metal.
No panels were replaced.
Holes for Malibu trim were filled.
Car now has SS emblems.
Car has 5 coats of paint & clear.
Tuxedo Black.
SS stripe is vinyl and red.
ALL NEW:
Glass - AMD, along with new wing windows and frames
Window felts
All weatherstripping
Bumpers, trim, grille, tail lights, emblems ALL NEW
Interior sheetmetal, trunk, and doors sprayed with Lizard Skin Sound deadening and heat protection liner as well as underside of car
Firewall had minor imperfections repaired but otherwise retain a factory look, sprayed with 40% gloss.
Interior was going to be all red. Body shop sprayed dash, steering column, steering wheel & top of doors red to match factory color.
Has bucket seats and rear seat but will need to be recovered.
Has console (fair cond.)
No Carpet, door panels or top.
Car originally had a manual top.
On this year, you can't just add the hydraulics to the frame and convert it to power, it requires a frame specifically for power. It isn't reproduced but I found a used one from Chicago and that comes with the car. It is not installed currently.
Currently has 15x8" Rallys x 4 with 245/60 front & 275/60 rear tires.
1 beauty ring, 3 disc brake caps.
Car was purchased & built with the intention of keeping.
Needs right person to complete it.
Description is honest, open to any/all question.