68 Camaro Project Car

1968 Chevrolet Camaro RS/SS Clone Additional Info:

68 Camaro project car that's been taking too much room in my shop for the last couple years. Clear Washington title in my name.No motor or trans, parting it all out.Cowl induction hood w/New hingesRS kit for front and rear, not finished.New windshieldNew radiator support.New dash and upper cowl, was rusted out and drag race hacked.Good working steering wheel and columnChrome 7 inch dual diaphragm brake boosterVintage air AC systemManual rack and pinion steering with chrome linkage.Polyurethane body subframe bushingsNew surface rusted 14 inch generic disc brakes front, single piston1 1/8 Hotckis front sway barTubular upper and lower control armsQA1 double adjustable shocks in frontQA1 shocks in rear not adjustable12 bolt rear end 3.07 gears needs cleaningTriangulated 4 link in rear w/anti sway bar. needs finishing11 inch disc brakes rearMini tubbed, almost finishedCorvette grand sport rims and tires8x18 front12x19 rearNew Fuel injection gas tank w/return line optionFront and rear spoilerAll glass with regulatorsFront and rear seats, (need redone, i have new pads and covers)160mph gauge clusterNew engine compartment wiring harnessDash wiring harness, not newBlack Interior kit
I replaced a couple rust spots in the floor board and fixed trans tunnel that was hacked up for 4 speed linkage( I was going to do a th400). Also a spot in the trunk and had to cut out some rear subframe and replaced it with 2 5/8 chromoly pipe to tie it in. Can be converted back to leaf springs and 4 link taken out. Email any questions and I will try to get to them as fast as I can.
If price goes over $15k or you Buy it now for $15000 and will throw in a 4 bolt main 454 with EBay 300cc aluminum heads. Studs,COMETIC head gaskets .600 lift cam, roller rockers and lifters, push rods, aluminum intake. Good working Th400 w/ torque converter. Not finished.
Car is located in Spokane, Wa. area.