1972 Chevrolet C-10 Shortbed Stepside Pickup

1972 Chevrolet C-10 Additional Info:

Selling my 1972 ORIGINAL short-bed step-side C-10 Pickup Truck. Itcame stock with an Inline 6 250 Cu inchengine

Started a motor swap to a SBC V-8 327 with 350 heads.

New Headers

New Intake Manifold

Rebuilt Carb

Saginaw 3 speed manual transmission with brand new clutch and throw-out bearing (shifter on the floor)

All seals are brand new on engine

Engine has new Cam and lifters

New engine mounts and rubber.

Brand new Painless wiring harness

New HEI Distributor and plug wires

New Spark Plugs

New Alternator

New Water pump

AZ truck its whole life as far as I know, Little to Zero rust (some on cab floor when I purchased in 2003)

Flowmaster 40's ready to be installed on headers

2 inch drop springs installed in the front and 3 inch drop blocks installed in the back.

Engine was running when I purchased for the install, I don't have the clutch linkage (Z-Bar) for the transmission so it has not run since I installed it.

Needs new tires and New rear Drums and belts.

The front bumper was not installed when I purchased the truck and I don't have one for it.

This is a GREAT project truck.

Unaware of total Mileage.

Buyer is responsible for Shipping or Pickup.