1996 Chevrolet Chevelle

1966 Chevrolet Chevelle Additional Info:

Chevrolet Chevelle . Condition is Used. Hello the car has no motor or trans. There is a ton of money in i, I have all the receipts. The front end has everything brand new and every part I put into the car,guaranteed,is made in the USA. Tie rods has tubular adjustment sleeves, center drag link, spindles, steering arms, idler arm and pitman arm are by Global West, the upper and lower control arms are Global Wes, manual steering box is NO, coilovers are QA1, rotors Wilwoo, calipers Wilwood, D 52 with Wilwood stainless steel lines, Wilwood combination proportioning valve with brake light switch. That is a lot of money in that front end. Had to replace body mounts so took body off frame and brought frame to a master builder welder, put frame in a ji, it was 100% square, he boxed in the fram, put gussets on each side of stock crossmembe, then six inches up, put in two by three square crossmember.He welded in a trick chassis sway bar, and you can see all of his work in photos.I put body back on with billet body mounts, those were over three hundred bucks for those mounts. Now rear suspension, rear control arms, lowers are tubular double adjustable rod ends, and uppers are adjustable with rod ends those are manufactured by trick chassis. Rear end 10 bolt positraction with 4/11. Has a complete fuel system, filters Earl's, fittings Fragola, fuel line Aeromotive, billet Quick Fuel pump, billet Quick Fuel fuel regulator, Jaz fuel cell Battery box, and Taylor battery cables 0/1 cables 960 strand positive and negative 20 ft. eac, billet line lock by TCI, steering column 3/4in stainless steel shaft 2 U joints one 1in coming out of the fire wall, other coming right off the box,leaves you room to get around anything.Moroso SFI approved quick release steering wheel, MOONS blue metal flake, aluminum PRO Kirkey seat .The rear drum brakes, are all new brake lines and fittings that need to be installed. There are a few more things that need to be installe, I forgot, I am sure I forgot lots of items, rear brakes completely new in there boxes. I did not know if I wanted to drag race it or put back on street. There are no seats, door panels or headline, but I have all the other stuff I knew I would need to put it right back on the street. I had a 10 point roll bar put in, ATI-WINTERS gate shifter, it can be a 2 or 3 speed, the body work and paint was done three years ago, PPG hot rod black. There is so much more!!! i your willing to do a little wor, it really is a great deal. Has low reserve so bid your max. vin number 134116B152388 Thank You